King City Overhead Door Repair

King City Overhead Door Repair

King City Overhead Door Repair team takes care mainly of overhead garage doors, residential and commercial as one. King City Overhead Door Repair team will arrive at your door fully prepared and equipped with everything necessary to assist you with any and all your garage door problems. King City Overhead Door Repair team is always on call, always ready 24/7 to come and service the doors on your property. Call us now!

King City Overhead Door Repair
King City Overhead Door Repair

A typical overhead garage door consists of several panels hinged together that roll along a system of tracks guided by rollers. Either a torsion spring system or a pair of extension springs balances the weight of the door.

A torsion spring counterbalance system consists of one or two tightly wound up springs on a steel shaft with cable drums at both ends. The entire apparatus mounts on the header wall above the garage door and has three supports: a centre bearing plate with a steel or nylon bearing and two end bearing plates at both ends. The springs themselves consist of the steel wire with a stationary cone at one end and a winding cone at the other end. The stationary cone is attached to the centre bearing plate. The winding cone consists of holes every 90 degrees for winding the springs and two set of screws to secure the springs to the shaft. Steel counterbalance cables run from the roller brackets at the bottom corners of the door to a notch in the cable drums. When the door is raised, the springs unwind and the stored tension lifts the door by turning the shaft, thus turning the cable drums, wrapping the cables around the grooves on the cable drums. When the door is lowered, the cables unwrap from the drums and the springs are rewound to full tension.

An extension spring counterbalance system consists of a pair of stretched springs running parallel to the horizontal tracks. The springs lift the door through a system of pulleys and counterbalance cables running from the bottom corner brackets through the pulleys. When the door is raised, the springs contract, thus lifting the door as the tension is released.

If you are experiencing any problems with this system, all you have to do is call our team to repair it. We do the job on the same day and will leave only when you are please with our service.

Leave a Comment

Your email address will not be published. Required fields are marked *

Scroll to Top